HP b2600 Supplementary Manual page 106

Parts removal and replacement guide
Hide thumbs Also See for b2600:
Table of Contents

Advertisement

Remove/Replace Flexible Disk Drives
Replacing the Flexible Disk Drive
8. Slide the flexible disk drive bay and flexible disk drive back into the workstation. You will hear
the retainer clips snap in place when the flexible disk drive bay and flexible disk drive are
properly installed. See
Figure D-16
Replace the Flexible Disk Drive and Flexible Disk Drive Bay
Flexible Disk Drive
Retainer Clip
9. Plug the flexible disk drive's power cable connector into its connector on the system board. See
.
Figure D-17
Figure D-17
Connecting the Flexible Disk Drive Power Cable
Complete the procedure in the section "Replacing the Front Bezel and Top Cover" found in
10.
Chapter 1.
11.Connect and turn on the power to your system.
Determine that your DAT drive replacement was successful by executing the sam command as
12.
root. When the System Administration Manager window appears, double click the Disk
and File System icon and in the window that appears double click the Disk Devices icon. In
the next window that appears, you should see your flexible disk drive listed. If it is not listed,
repeat this procedure. If your flexible disk drive is still not listed, contact your local HP Support
Representative.
106
.
Figure D-16
Flexible Disk Drive
Retainer Clip
Power Cable
Connector
Appendix D

Advertisement

Table of Contents
loading

Table of Contents