HP b2600 Supplementary Manual page 92

Remove/Replace DAT Drives
Replacing the DAT Drive
4. Replace the DAT drive bay's back cover. Note that this back cover snaps onto the DAT drive bay.
See . Also, note that the audio, power and control cables must be neatly fed through
Figure C-11
the raised opening in the DAT drive bay's back cover to avoid pinching them.
Figure C-11 Replacing the DAT Drive Bay's Back Cover
DAT Drive
Bay
5. Align the DAT drive bay's mounting screw holes with the threaded holes on both sides of the
DAT drive and screw in the four mounting screws. See
Figure C-12 Removing the DAT Drive Bay and DAT Drive
DAT Drive Bay
DAT Drive
Mounting
Screws
92
Figure C-12
Mounting Screws
DAT Drive
Bay's Back
Cover
SCSI Terminator
.
SCSI Cable
Appendix C