Removing The Ac Or Dc Power Supply - HP b2600 Supplementary Manual

Remove/Replace System Components
Removing/Replacing System Components

Removing the AC or DC Power Supply

The HP B2600 workstation can be purchased with either an AC or DC power source. This
section covers how to remove the AC power supply. To learn how to remove the DC power
supply, see Appendix B in this document.
To remove the AC power supply, follow this procedure:
1. Unplug the power cord from the system as stated in the WARNING at the beginning of
this chapter.
2. Complete the procedure in the section "Removing the Front Bezel and Top Cover"
found in this chapter.
3. Disconnect the power supply cables from the system board by pressing in on the latch
releases on the connectors and pulling outward. See Figure 1-47.
Figure 1-47. Disconnect the Power Supply Cables
System Divider
Panel
Power Supply
Cables
System Board
42
Support Arm
Power Supply
Component
Heat Sink
Chapter 1