HP b2600 Supplementary Manual page 19

3. Grasp both edges of each DIMM card and insert the card into the appropriate slot. You
will need to push firmly downward on the card until the memory slot tabs snap in place.
See Figure 1-7.
Figure 1-7. Inserting the DIMM Card into a Memory Slot
DIMM Card
4. Complete the procedure in the section "Replacing the Front Bezel and Top Cover"
found in this chapter.
5. Connect and turn on the power to your system.
6. Determine that your memory installation was successful by executing the sam
command as root. When the System Administration Manager window appears,
select the System Properties icon. In the new window that appears, select the
Memory tab. The next window that appears will tell you how much memory you have
available. If the amount of memory you were expecting does not appear, repeat this
procedure. If the correct amount of memory still does not appear, contact your local HP
Support Representative.
Chapter 1
Remove/Replace System Components
Removing/Replacing System Components
DIMM Card
Slots
Memory Slot
Tab
19