Host Interface - Ricoh P7575 Operating Instructions Manual

Configuration
The [Menu] screen appears on the display.
B
Press the {U} or {T} key to display [Host Interface] menu, and then press
the {# Enter} key.
Menu:

Host Interface

The interface setting menu appears.
C
Press the {U} or {T} key to display [Network Setup], and then press the {#
Enter} key.
The network setup menu appears.
D
Press the {U} or {T} key to display [Active Protocol], and then press the
{# Enter} key.
The active protocol menu appears.
E
Press the {U} or {T} key to select Active Protocol, and then press the
{# Enter} key.
Active Protocol:
TCP/IP
The following example explains activating TCP/IP:
F
Press the {U} or {T} key to select [Active] or [Not Active], and then press
the {# Enter} key.
TCP/IP:
*Active
About two seconds after the settings are made, the screen returns to the ac-
tive protocol menu. To disable the setting, select [Not Active], and then press
the {# Enter} key.
G
Repeat above steps for any other protocols that need to be set.
H
Press the {Escape} key. The screen returns to the network setup menu.
The network setup menu appears.
❒ Enable TCP/IP to use the Pure IP environment of NetWare 5/5.1, NetWare
6/6.5.
I
To use TCP/IP, you must assign an IP address to the printer. Press the
{U} or {T} key to display [IP Address], and then press the {# Enter} key.
When DHCP is "On", you cannot make settings for the following items:
44