Table of Contents
Advertisement
Note
❒ If the Network Transmission
A u t o C h e c k f u n c t i o n i s
turned off, the display does
not appear. Proceed to step
E. See p.166 "User Parame-
ters" (switch 32, bit 1).
D Press the { { { { OK} } } } key.
E Confirm "Yes" is selected, and
then press the { { { { OK} } } } key.
The display for entering the
VoIP gateway address appears.
F Enter the IP address or host
name of the VoIP gateway.
Note
❒ If you use the gatekeeper, the
following display appears.
Enter the alias fax number
registered on the gatekeeper.
Reference
p.45 " Own Fax Number
(Alias Fax Number)"
G Press the { { { { OK} } } } key.
I I I I
Press the { { { { OK} } } } key.
Registering Addresses for IP-Faxing
J J J J
Enter the name of the receiver.
Note
❒ To edit the currently registered
name, press the { { { { Clear/Stop} } } } key
to delete the name shown, and
then enter the new name.
Reference
Chapter 3 "Entering Charac-
ters", Basic Features
K K K K
Press the { { { { OK} } } } key.
L L L L
Press the 0 0 0 0 or 1 1 1 1 key to select
"On" or "Off".
Reference
Chapter 3 "Label Insertion", Ad-
vanced Features
M M M M
Press the { { { { OK} } } } key.
N N N N
Press the 0 0 0 0 or 1 1 1 1 key to select
"Hdr.1 (Fax Header 1)" or "Hdr.2
(Fax Header 2)".
O O O O
Press the { { { { OK} } } } key.
The destination is registered.
Note
❒ To register another Quick Dial
destination, repeat the proce-
dure from step
P P P P
Press the { { { { User Tools} } } } key.
The standby display reappears.
E
.
145
8
Advertisement
Table of Contents
