Maintenance / Check - SMC Networks IZS51 Series Operation Manual

l. Locations which are subject to potential lightning strikes.
m. In an area where the product may receive direct impact or vibration.
n. Areas where the product may be subjected to forces or weight that could cause physical deformation.
4) Ionizer, Remote controller and AC adapter are not resistant to lightening surge.
Warning
1) Perform maintenance regularly and clean the emitters.
· Check regularly that the product is not operating with undetected failures.
· The maintenance must be carried out by an operator who has sufficient knowledge and experience.
· If the product is used for an extended period with dust present on the emitters, the product performance will
be reduced.
· Maintenance detection function is installed to this product. When the emitter contamination is detected,
clean the emitter.
· In cases where the maintenance detection function is not used on this product is used, perform neutralizing
performance test and set maintenance cycle for periodic cleaning.
· Emitter contamination level is different depending on the installation environment.
· If the performance is not recovered after cleaning, it is possible that emitters are worn. Replace the emitter
cartridge.
2) Be sure to remove power supply and air supply to the Ionizer before cleaning the emitter or replacing
the emitter cartridge.
· Never touch the emitter with the power supplied to the
ionizer. Electric shock may cause injury.
· If the emitter cartridge is removed while air is supplied,
the emitter cartridge jumps out by compressed air.
Replace the emitter cartridge after discharging the
supply air.
· If emitter cartridges are not securely mounted to the
ionizer body, they may eject or release when air is
supplied to the product.
· Securely mount or remove the emitter cartridges
referencing the instructions shown below.
· Securely mount or remove the emitter cartridges with
hands and do not use tools.
(1) Rotate the cartridge 60
in the counter-clockwise
direction.
Remove of the emitter cartridge
3) Do not disassemble or modify the product.
· Disassembling or modifying the product may cause product, electric shock or fire. The product will not be
guaranteed if it is disassembled and/or modified.
4) Do not operate the product with wet hands.
· Never operate the product with wet hands. It may cause electric shock or other accidents.

Maintenance / Check

o
(2) Pull to remove.
High voltage caution
· This product contains a high voltage
generation circuit. When performing
maintenance inspection, be sure to
confirm that the power supply to the
ionizer is turned off.
· Never disassemble or modify the
product, as this can cause loss of
product functionality, and there is also a
risk of electric shock and earth leakage.
(1) Insert the emitter (2) Rotate the cartridge 60
cartridge.
Mounting of the emitter cartridge
8
o
clockwise direction until it is parallel
to the groove on the bottom of the
Ionizer, then secure it in place.
in the