Troubleshooting And Maintenance - ETC ColorSource CYC v1.7 Installation Manual

ETC Installation Guide
ColorSource CYC v1.7/v3.1/v4.0

Troubleshooting and Maintenance

Update the Fixture Software
ETC recommends using UpdaterAtor software to manage software
updates. For information on UpdaterAtor, see the UpdaterAtor Software
Quick Guide and the UpdaterAtor Software Release Note , which you can
download from etcconnect.com.
You can push newer software versions from a connected fixture to selec-
ted ColorSource fixtures (see table that follows).
Note:
not need to disconnect them before pushing the updated fixture
software. The update process will ignore any other fixture types in
the DMX run.
Note:
version number appears on the display when the fixture powers
up.
This fixture...
CYC v1.7 or earlier
CYC v3.1
CYC v4.0
Linear v1.7 or
earlier
PAR v1.7 or earlier
PAR v3.0
PAR v4.0
Spot v1.7 or earlier
Spot v3.0
1. Remove power and DMX In from the fixture that is running the
software version that you want to push to other fixtures.
2. Press and hold the Up button and Down button simultaneously
while restoring power.
3. The display shows
selected.
ColorSource CYC
If you have other types of fixtures in your DMX run, you do
Not sure what version of fixture software is installed? The
...can push software to these fixtures/releases when connected
CYC
≤ v1.7
v3.1
X
X
X
X
X
Udt rdy
Linear
≤ v1.7 ≤ v1.7
v4.0
X X
X
X X
X X
X X
to indicate the update mode is
Page 9 of 12
PAR Spot
≤ v1.7
v3.0 v4.0
X
X
X
X
X
X
X
v3.0
X
X
ETC