ETC ColorSource CYC v1.7 Installation Manual page 4

ETC Installation Guide
ColorSource CYC v1.7/v3.1/v4.0
Connectors
• Power: Two powerCON
• Data (DMX512/RDM): Two five-pin XLR connectors for data in and
thru
Note:
minate the last fixture in line with a 120 Ohm resistor. To pur-
chase a terminator, please contact ETC customer service and
request part number SGE1507 (XLR terminator).
Set Up the Fixture
1. Plug the power cord into the powerCON In connector on the rear of
the fixture.
2. Make any power-thru cable connections prior to applying a power
source.
3. Make any DMX connections, and if the fixture is the last in a DMX
line, terminate the fixture. See
4. Position the fixtures appropriately. You can use the MyETC:
Photometrics app to determine best fixture positioning (visit
etcconnect.com/fixtureapps). Position fixtures based on the
following parameters:
• Setback: Minimum recommended distance from the cyclorama
• Spacing: Position the fixtures arrayed with a 1.7-1 spacing for
5. Plug the power cord into the power source.
Power Up
Press any button to wake the display. The display shows the DMX
address. See
You can press the Mode button to access the Presets/Sequences menu.
See Play Presets and Sequences on page 7
ColorSource CYC
The ColorSource CYC is not self terminating. You must ter-
is 2 ft (.61 m).
optimal coverage, with a maximum spacing of 2-1. For
example, if fixtures are 2 ft (.61 m) from the cyclorama,
position them a maximum of 4 ft (1.22 m) apart from each
other.
Set the DMX Address on the facing page
®
connectors for power in and thru
Connectors above
.
Page 4 of 12
.
.
ETC