Restore Factory Defaults; Error Codes; Clean The Fixture - ETC ColorSource CYC v1.7 Installation Manual

ETC Installation Guide
ColorSource CYC v1.7/v3.1/v4.0
4. Press the Mode button to start the update process.
• The first time that you push an updated software version,
• The display alternates between
• The display returns to its previous value (DMX address or active
5. Reconnect DMX In on the fixture.

Restore Factory Defaults

Press and hold the Mode button, Up button, and Down button sim-
ultaneously for 3 seconds. The DMX start address will blink once to con-
firm that defaults have been restored.

Error Codes

These error codes may display on the user interface.
• CAL
with the color calibration. The fixture will need to be returned to
the ETC factory; contact your local dealer to set up a repair.
• OtP
fixture has gone into over-temperature protection mode to avoid
damaging the fixture. Once the fixture has self-cooled, the error
will automatically clear. If the error does not clear, contact
ETC Technical Support (visit etcconnect.com/contactETC).
• Udt Err
the software update failed. Reload software to clear the error. If
the error persists, contact ETC Technical Support (visit
etcconnect.com/contactETC). For CPU3 fixtures: You can also
power cycle the fixture to clear the error, and then update the
software at a later time.
• No App
upgraded fixtures have a software issue. Reload software to clear
the error. If the error persists, contact ETC Technical Support (visit
etcconnect.com/contactETC).

Clean the Fixture

If necessary, clean the mirror and diffusion surface with a blast of oil-free
air or wipe with a clean, lint-free cloth. Isopropyl alcohol, distilled water,
or a 50%-50% mixture of each can be used to clean the surface.
ColorSource CYC
additional required files must be copied before the update can
begin. The display alternates between
indicate the percentage complete while required data is
copied.
complete while updating the connected fixtures.
preset) to indicate that the update is complete.
: Screen toggles between
: Screen toggles between
: Screen toggles between
: Screen toggles between
Udt
and the percentage
CAL Err
and
OtP Err
and
Udt
and
no
and
Page 10 of 12
Udt c:XX
and to
to indicate a problem
to indicate that the
Err
to indicate that
APP
to indicate that the
ETC