Dmx Control Channels; Data Loss Behavior - ETC ColorSource CYC v1.7 Installation Manual

ETC Installation Guide
ColorSource CYC v1.7/v3.1/v4.0
4. Press the Mode button to confirm your selection.
If you do not press the Mode button, the display will automatically
return to the DMX address after 10 seconds of inactivity, and edits
will not be saved. This cancels unsaved changes.
Note:
ibrated mode. As a result, you may see discrepancies in color
between fixtures. ETC recommends operating in one of the cal-
ibrated modes, such as 5-channel mode or RGB mode. (Calibrated
modes make accommodations for the specific LEDs in the array
and produce output that is consistent with other fixtures. Direct
mode bypasses this calibration, and multiple fixtures may produce
slightly different outputs when controlled as a group.)

DMX Control Channels

5ch
DMX
Channel
(5 channel)
1
2
3
4
5
6
7
*Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increase the strobe rate
from 1 per second up to 33 per second.

Data Loss Behavior

When DMX data is lost, the fixture does one of the following actions:
• If you selected a preset or sequence, that preset or sequence
automatically plays.
• If no preset or sequence is active in the background, the fixture
goes dark and the DMX start address flashes on the user interface.
ColorSource CYC
dir
Direct mode (
dir
(Direct)
Intensity Intensity
Red Red
Green Green
Blue Blue
Strobe* Indigo
Lime
Strobe*
) on the ColorSource CYC is not a cal-
1ch
(1 Channel)
Intensity
Page 6 of 12
rgb
(RGB)
Red
Green
Blue
ETC