TRENDnet TW100-BRV304 User Manual page 83

General Settings
Policy Name
Enable Policy
Allow NetBIOS
traffic
Remote VPN
Endpoint
Keys
2. Click Next to continue. You will see a screen like the following:
Figure 50: VPN Wizard – General Screen
Enter a suitable name. This name is not supplied to the remote VPN. It is
used only to help you manage the policies.
Enable or disable the policy as required. For each remote VPN, only 1
policy can be enabled at any time.
Enable this if you require NetBIOS traffic to be transferred through the
VPN tunnel. NetBIOS is used by Microsoft (Windows) networking. This
setting should not be enabled unless necessary, because it increases
traffic volume.
The Internet IP address of the remote VPN endpoint (Gateway or client).
•
Dynamic. Select this if the Internet IP address is unknown. In this
case, only incoming connections are possible.
•
Fixed. Select this if the remote endpoint has a fixed Internet IP
address. If selected, enter the Internet IP address of the remote end-
point.
•
Domain Name. Select this if the remote endpoint has a Domain
Name associated with it. If selected, enter the Domain Name of the
remote endpoint.
Select Manually assigned or IKE (Internet Key Exchange) as required.
If you are setting up both endpoints, using IKE is recommended.
Microsoft VPN
79