Check The Leds - TRENDnet TW100-BRV304 User Manual

TW100-BRV304 User's Guide
•
If desired, connect a PC (server) to the DMZ port. To use multiple servers, use a standard
LAN cable to connect the DMZ port to a normal port on another hub, and connect your
servers to the hub. PCs connected to the DMZ port are isolated from your LAN.
3. Connect WAN Cable
Connect the Broadband modem to the WAN port on the TW100-BRV304. Use the cable
supplied with your Broadband modem. If no cable was supplied, use a standard LAN ca-
ble.
4. Power Up
•
Power on the Broadband modem.
•
Connect the supplied power adapter to the TW100-BRV304 and power up.
Use only the power adapter provided. Using a different one may cause hardware damage

5. Check the LEDs

•
The Power LED should be ON.
•
The Status LED should blink during start up, then turn Off. If it stays on, there is a hard-
ware error.
•
For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is
also ON.)
•
If a PC is connected to the DMZ port, the DMZ port's Link/Act LED should be ON (pro-
vided the PC is also ON.)
•
The WAN LED should be ON.
For more information, refer to Front-mounted LEDs in Chapter 1.
8