Connection Status - Telstra Big Pond - TRENDnet TW100-BRV304 User Manual

TW100-BRV304 User's Guide
Refresh

Connection Status - Telstra Big Pond

An example screen is shown below.
Data - Telstra Big Pond Screen
Connection
Physical Address
IP Address
Connection Status
Connection Log
Connection Log
Update the data on screen.
Figure 23: Telstra Big Pond Status Screen
The hardware address of this device, as seen by remote devices.
(This is different to the hardware address seen by devices on the
local LAN.)
The IP Address of this device, as seen by Internet users. This
address is allocated by your ISP (Internet Service Provider).
This indicates whether or not the connection is currently estab-
lished.
•
If the connection does not exist, the "Connect" button can be
used to establish a connection.
•
If the connection currently exists, the "Disconnect" button can
be used to break the connection.
•
Normally, it is not necessary to use the Connect and Discon-
nect buttons unless the setting "Connect automatically, as
required" is disabled.
•
The Connection Log shows status messages relating to the
existing connection.
•
The Clear Log button will restart the Log, while the Refresh
button will update the messages shown on screen.
38