Power Connector; Reset Button - TRENDnet TV-IP400 User Manual

1. Power Connector

The DC power input connector is located on the camera's rear
panel, and is labeled DC5V 2.5A with a single jack socket to
supply power to the camera. Power will be generated when the
power supply is connected to a wall outlet.

2. Reset Button

Reset will be initiated when the reset button is pressed once, and
Power LED begins to flash.
Factory Reset will be initiated when the reset button is pressed
continuously for three seconds or when Power LED begins to
light up. Release the reset button and the Power LED will begin
to flash, indicating the camera is changing to factory reset. When
factory reset is completed, the camera will be set to default on
channel 11 and SSID is set as "NULL String" (This default
setting will let the camera connect to ANY access point on the
infrastructure network). The IP address will also return to the
default setting as 192.168.0.20.
3. LAN Port
The RJ-45 connector is used to connect the 10Base-T Ethernet or
100Base-TX Fast Ethernet network (which should be Category 5
twisted-pair cable). The port supports the Auto-MDIX which
allowing the camera automatically detects or negotiates the
transmission speed of the Network.
11