Table of Contents
Advertisement
Connect Ethernet Cable
To connect the camera to your network, connect a Category
5 or better Ethernet cable to the network cable connector
located on the camera's left side panel, and then attach it
to the network. The Ethernet port will automatically detect
and adjust to the speed (10 or 100 Mbps) and polarity
(Auto‐MDIX) of the connection.
Connect Power using AC Adapter and Power on Camera
To provide power to the camera, connect the AC power
adapter to the DC power input connector, also located on
the camera's left side panel, and then plug it to the
electrical outlet. As with any electrical device, make sure
the power source and camera are located in an area where
it is not going to get wet or present an electrical hazard.
CAUTION: The Camera must be used with the power adapter
included with the device.
TV‐IP602WN ProView Wireless N Pan/Tilt Internet Camera
12
Advertisement
Table of Contents
