Connect Ethernet Cable; Connect Power Using Ac Adapter And Power On Camera - TRENDnet ProView TV-IP512P User Manual

Connect Ethernet Cable

To connect the camera to your network, connect a
Category 5 or better Ethernet cable to the network
cable connector located on the camera's left side
panel, and then attach it to the network. The Ethernet
port will automatically detect and adjust to the speed
(10 or 100 Mbps) and polarity (MDI-II or MDI-X) of the
connection.

Connect Power using AC Adapter and Power On Camera

To provide power to the camera using the AC Adapter,
connect the AC power adapter to the DC power input
connector, also located on the camera's left side panel,
and then plug it to the electrical outlet. As with any
electrical device, make sure the power source and
camera are located in an area where it is not going to
get wet or present an electrical hazard.
TV-IP512P ProView PoE Internet Camera
CAUTION: The Camera must be used with the power
adapter included with the device.
11