Maintenance; Replacing The Rubber Pad - Microtek FileScan 2325 User Manual

Maintenance

The rubber pad in your ADF is designed to make document feeding smooth. After
scanning approximately 20,000 pages through the ADF, the rubber pad may
become worn out, and a problem such as a document double-feed may occur.
In this case, check the rubber pad, and replace it with a new one if needed.
For ordering the rubber pad, please consult your nearest dealer and follow the
procedures below for replacement of the rubber pad.

Replacing the Rubber Pad

1. Open the ADF cover.
2. With the cover fully opened, press the rubber pad inward with your fingers in
3. Insert and push the new rubber pad into its the compartment until it snaps
4. Close the ADF cover and you will hear the cover snap and close.
42 FileScan 2325 User's Manual
Locate the notch at the edge of the cover and then hold it to pull the cover
up.
the direction of the arrow shown as indicated in the graphic to lift the rubber
pad up slightly. Next, hold the both sides of the rubber pad, nip it off and
then take it out from its compartment.
into place.
Rubber pad