Connecting An External Control Device; Remote Control Jacks; Trigger Out Jacks - Denon AVR-2312CI Owner's Manual

Connecting an external control device

REMOTE CONTROL jacks

If this unit is installed in a location that is out of range of the signal
from the remote control unit, you can still operate the unit and the
devices connected to it by using a commercially available IR receiver.
You can also use it to remotely control ZONE2 (another room).
Infrared
Infrared
retransmitter
sensor
Device equipped with a
REMOTE CONTROL IN jack
Output
Input
AUX
OUT
RS-232C connector
When you connect an external control device, you can control this unit
with the external control device.
External serial controller
Perform the operation below beforehand.
q Turn on the power of this unit.
w Turn off the power of this unit from the external controller.
e Check that the unit is in the standby mode.
18

TRIGGER OUT jacks

When a device with TRIGGER IN jack is connected, the connected
device's power on/standby can be controlled through linked operation
to this unit.
The TRIGGER OUT jack outputs a maximum 12 V/150 mA electrical
signal.
12 V/150 mA trigger-compatible device
in Set as Necessary
Set to change the conditions for linked operation via the TRIGGER
OUT jack.
"Trigger Out" (vpage 114)
NOTE
• Use the monaural mini-plug cable for connecting TRIGGER OUT
jacks. Do not use the stereo mini-plug cable.
• If the permissible trigger input level for the connected device is larger
than 12 V/150 mA, or has shorted, the TRIGGER OUT jack cannot be
used. In this case, turn off the power to the unit, and disconnect it.