Denon AVR-2312CI Owner's Manual page 69

4
Use o p to select the
configuration of the connected
speakers.
NORMAL Select the "NORMAL" setting to perform 7.2-channel
playback using the surround back or front height
speakers.
ZONE2 Select the "ZONE2" setting to assign the unit's built-
in power amplifier for ZONE2 and output the audio
in stereo.
Bi-AMP Select the "Bi-AMP" setting to connect the front
speakers via the bi-amp connection.
2CH When you perform 2-channel playback in the DIRECT
or STEREO mode, select the "2CH" setting to use
the other front speakers for playback.
Front B Select the "Front B" setting to use the second set of
front speakers for playback.
F.Height Select the "F.Height" setting to use the front height
speaker for playback.
5
RETURN B
Press to exit the "Amp Assign" setting.
6
Set up "Channel Select"
Use ui to select "Channel Select", and then press
ENTER
.
AUDYSSEY AUTO SETUP
STEP1 Preparation 1 2 3 4 5 6
Connect the speakers and place them according
to the recommendations in the manual,
Set the following items
If necessary.
Amp Assign
Channel Select
Auto Setup Start
Enter Cancel
RETURN
Enable skip of measuring unused channels to reduce time
AUDYSSEY AUTO SETUP
Channel Select
STEP1 Preparation 1 2 3 4 5 6
Connect the speakers and place them according Subwoofer Measure
to the recommendations in the manual,
Set the following items
If necessary.
Amp Assign
Channel Select
Measure subwoofer channel
Auto Setup Start
Enter
Cancel
RETURN
Enter Cancel
RETURN
Enable skip of measuring unused channels to reduce time
66
7
Use ui to select a channel.
Front Select for setting the front speakers to be used. In this
case, go to step 8.
• "Front" can be set when "Amp Assign" is set to
"Front B".
Subwoofer Select for no subwoofers to be used. In this case, go
to step 9.
Surround
Select the number of surround back speakers to be
Back
used. In this case, go to step 10.
• "Surround Back" can be set when "Amp Assign" is
set to "NORMAL".
Front
Select for no front height speakers to be used. In this
Height
case, go to step 11.
• "Front Height" can be set when "Amp Assign" is set
to "F.Height".
8
Press o p to select a front speaker.
A
Select this to use front speaker A.
B
Select this to use front speaker B.
A+B Select this to use front speakers A and B simultaneously.
Set up speakers
vSee overleaf