Denon AVR-2312CI Owner's Manual page 107

Setting items
Distance Unit : Set the unit of distance.
Set distance from listening • Feet / Meters
position to speakers.
Step : Set the minimum variable width of the distance.
Measure beforehand the
• 1ft / 0.1ft
distance from the listening
• 0.1m / 0.01m
position to each speaker.
Default : The "Distance" settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select "Default" and press
the "Return all settings to the default?"
prompt is displayed. Select either "Yes" or
"No", and press
Front L / Front R / Center / Subwoofer / Surround L / Surround R /
z
Surr.Back L
speaker.
z When the "Speaker Config." – "Surr.Back" setting
set to "1spkr", "Surr.Back" is displayed.
• 0.0ft – 60.0ft / 0.00m – 18.00m : Set the distance.
• The speakers that can be selected differ depending on the "Amp Assign"
(vpage 102) and "Speaker Config." (vpage 102) settings.
• Default settings :
Front L / Front R / Center / Subwoofer / F.Height L / F.Height R : 12.0 ft
(3.60 m)
Surround L / Surround R / Surr.Back L / Surr.Back R : 10.0 ft (3.00 m)
• Set the difference in the distance between the speakers to less than
20.0 ft (6.00 m).
NOTE
Speakers set to "None" in "Speaker Config."
displayed.
BD
Setting details
ENTER
,
ENTER
.
z
/ Surr.Back R / F.Height L / F.Height R : Select the
(vpage
(vpage
Setting items
Channel Level
Set the volume of the test
tone to be the same when it
is output from each speaker.
103) is
102) are not
104
Setting details
Test Tone Start : Output test tone.
• Front L / F.Height L / Center / F.Height R / Front R / Surround R /
z z
/ Surr.Back L / Surround L / Subwoofer : Select the
Surr.Back R
speaker.
z When the "Speaker Config." – "Surr.Back" setting
set to "1spkr", "Surr.Back" is displayed.
• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.
When "Channel Level" is adjusted, the adjusted values are set for all the
surround modes. To adjust the channel level separately for the different
surround modes, use the operation see page 70.
NOTE
• Speakers set to "None" in the "Speaker Config."
settings are not displayed.
• When a headphones jack is inserted in the PHONES jack of this unit, the
"Channel Level" is not displayed.
Default : The "Channel Level" settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
ENTER
When you select "Default" and press
the "Return all settings to the default?"
prompt is displayed. Select either "Yes" or
ENTER
"No", and press .
SYSTEM SETUP
(vpage 103) is
(vpage 102)
,
vSee overleaf