Denon AVR-2312CI Owner's Manual page 108

Setting items
Crossover Freq. 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
Set the maximum frequency 250Hz : Set the crossover frequency.
of the bass signal output
Advanced : Specify crossover frequency for each speaker.
from each channel to
• Front / Center / Surround / Surr.Back / Front Height : Select the
the subwoofer. Set the
speaker.
Crossover Frequency to
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
suit the bass reproduction
250Hz : Set the crossover frequency.
capability of the speaker
being used.
• "Crossover Freq." can be set when the "Bass Setting" – "Subwoofer
Mode" (vpage
speaker that is set to "Small".
• Always set the crossover frequency to "80Hz". When using small
speakers, however, we recommend setting the crossover frequency to
a higher frequency.
• For speakers set to "Small", sound below the crossover frequency
is cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• The speakers that can be set when "Advanced" is selected differ
depending on to the "Subwoofer Mode" setting (vpage 103).
• When "LFE" is selected, speakers set to "Small" at "Speaker Config."
can be set. If the speakers are set to "Large", "Full Band" is displayed
and the setting cannot be made.
• If set to "LFE+Main", this setting can be made regardless of the
speaker size.
Front Speaker Setup 2CH DIRECT/STEREO : The front speakers used in the direct, stereo and
Set the front speakers to pure direct play modes (2 channel) are set in advance.
use for every surround • A : Front speaker A is used.
mode. • B : Front speaker B is used.
• A+B : Both front speakers A and B are used.
NOTE
MULTI CH : The front speakers used in modes other than the direct,
This can be set when "Amp
stereo and pure direct play modes (2 channel) are set in advance.
Assign" is set to "Front B"
• A : Front speaker A is used.
(vpage 102).
• B : Front speaker B is used.
• A+B : Both front speakers A and B are used.
BD
SYSTEM SETUP
Setting details
103) setting is "LFE+Main", or when you have a
105