Set Up Speakers - Denon AVR-2312CI Owner's Manual

Set up speakers

Here we describe how to set up speakers other than 5.1-channel speakers.
For the method of setting up 5.1-channel speakers, see
First install and connect the speakers to this unit.
Before Auto Setup measurement, the settings shown below can be made.
• Changing the amplifier assignment (Amp Assign)
The signal output from the SURR.BACK/AMP ASSIGN speaker terminal of this unit can be switched to match your speaker environment
• Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers
"Set up "Channel Select"").
1
Set up the
remote control unit
n Set up the zone mode
ZONE SELECT
Press to switch the zone mode to
J (MAIN ZONE).
J
The indicator lights.
Press ZONE SELECT
n Set up the operation mode
Press AMP to set the remote control unit to AMP-
operation mode.
Press AMP
C page 4 "SETUP WIZARD".
2
Connect the setup microphone.
When the setup microphone is
connected, the following screen is
displayed.
AUDYSSEY AUTO SETUP
STEP1 Preparation
Connect the speakers and place them according
to the recommendations in the manual.
Set the following items
If necessary.
Amp Assign
Channel Select
Auto Setup Start
Enter
Start Auto Setup
(vpage 65
3
1 2 3 4 5 6
Cancel
RETURN
65
around items indicate the settings.
"Set up "Amp Assign"").
Set up "Amp Assign"
ui
Use to select "Amp Assign", and then press
ENTER .
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
STEP1 Preparation
Connect the speakers and place them according
to the recommendations in the manual,
Set the following items
If necessary.
Amp Assign
Channel Select
Auto Setup Start
Enter Cancel
RETURN
Change assigned power amp to match the speaker system
AMP ASSIGN [1/2]
Assign Mode ZONE2
ZONE2:
Return
RETURN
Assign power amp to ZONE2 stereo signal
(vpage 66
vSee overleaf