<ZONE2/3 / REC SELECT>
• To cancel, press
SELECT>
until "ZONE2 Source" is displayed.
• Make a test recording before starting the actual recording.
• Signals are only output to the analog REC OUT connectors when
the digital signals input to the digital input connectors (OPTICAL/
COAXIAL) are PCM (2-channel) signals.
• Digital audio signals input to the HDMI connectors are not output
to the REC OUT connectors, so connect using the OPTICAL or
COAXIAL connectors.
• Sources selected with the REC OUT mode are output from ZONE2
as well.
• In the REC OUT mode, the remote control unit's ZONE2 mode
buttons cannot be operated.
• The "XM" digital audio output signal is not output from the OPTICAL2
output connector.
NOTE
• Recordings you make are for your personal enjoyment and should
not be used for other purposes without permission of the copyright
holder.
• Input sources for which "Delete" is selected at "Source Delete"
cannot be selected.
Convenient Functions
HDMI Control Function
When AVR-2809CI is connected to a TV and player compatible
with HDMI control function, you can perform the following
operations.
Settings other than AVR-2809CI settings must be made on the
respective devices. (Check the operating instructions of each
device for details.)
AVR-2809CI power off can be linked to the TV power off step.
•
When you set "Output audio from amp" in the TV audio output
setup operation, you can switch the amp power on.
You can switch audio output devices with a TV operation.
•
(When outputting from the TV speakers, output switches from
speakers connected to AVR-2809CI).
You can adjust AVR-2809CI volume in the TV volume adjustment
•
operation.
You can switch AVR-2809CI input source through linkage to TV input
•
switching.
When playing the player, the AVR-2809CI input function switches to
•
the function of that player.
<SOURCE
, then turn
• When you want to listen to TV audio by AVR-2809CI, connect optical
digital or analog.
If the TV you are using has both connection jacks, use the optical
digital connection.
• When using these functions set as follows: menu "Manual Setup" –
"HDMI Setup" – "HDMI Control" set to "ON" (vpage 29).
Connections
NOTE
When using the HDMI control function, do not assign HDMI input to "TV/
CBL" by setting "Input Setup" – "Assign" – "HDMI In" in the menu.
Player compatible
Television compatible with
with HDMI
HDMI control function
control function
L
L
R
R