Parameter Check; Error Messages - Denon AVR-2809CI Owner's Manual

Step 5 : Store
F Menu screen F
q
Auto Setup
Audyssey MultEQ XT
Auto Setup
Step5:Store
Please select "Store"
Step5:Store
to store measurement
Storing
values.
Please wait...
Store
Cancel
The auto setup measurement results are stored in the AVR-2809CI.
q Select "Store 0", then press .
o
• "Storing Please wait ... " is displayed on the on-screen display
while the results are being stored.
• When storing is complete, "Storing complete. Auto Setup is now
fi nished." is displayed on the on-screen display.
ENTER
w Select "Exit", then press .
e Disconnect the setup microphone from the AVR-2809CI.
n To cancel storing
Press ui to select "Cancel 0", then press
• All the measured auto setup data will be erased.
NOTE
Do not turn the power off while the settings are being stored.
s Parameter Check
Check auto setup measurement results.
This is displayed after the auto setup procedure is completed.
[Selectable items]
Speaker Confi g. Check Distance Check
Channel Level Check
Crossover Freq. Check
EQ Check
The auto setup results can be set again when "Restore" is selected.

Error Messages

If the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is
displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure over
again.
Error messages (examples)
Audyssey MultEQ XT
Auto Setup
Audyssey MultEQ XT
Caution!
Microphone:None
or
Speaker
Retry
Cancel
Auto Setup
Audyssey MultEQ XT
Caution!
Ambient noise is
too high or
Level is too low.
Retry
Cancel
o .
Auto Setup
Audyssey MultEQ XT
Caution!
Retry
Cancel
Auto Setup
Audyssey MultEQ XT
Caution!
Retry
Cancel
Skip
Select "Retry" to measure again.
NOTE Be sure to turn the power off before checking the speaker connections.
Cause
• Included setup microphone is not connected.
• Not all speakers could be detected.
• The front L speaker was not properly
:None
detected.
• Too much noise in the room for accurate
measurements to be made.
• Speaker or subwoofer sound is too low for
accurate measurements to be made.
• Displayed speaker could not be detected.
· The front R speaker were not properly
detected.
· Only one channel of the surround speakers
Front was detected.
· Sound was output from the R channel
R :None
when only one surround back speaker was
connected.
· The surround back, but the surround speaker
was not detected.
• Displayed speaker connected
polarities reversed.
Front
L :Phase
Measures
• Connect the included setup microphone to the SETUP
MIC jack on the main unit.
• Check the speaker connections.
• Either turn off any device generating noise or move it
away.
• Try again when the surroundings are quieter.
• Check the speaker installation and the direction in
which the speakers are facing.
• Adjust the subwoofer's volume.
• Check the connections of the displayed speaker.
with the • Check the polarities of the displayed speaker.
• For some speakers, this error message may be
displayed even if the speaker is properly connected. If
you are sure that the wiring is correct, select "Skip".