Checking The Xm Signal Strength And Radio; Presetting Radio Channels (Preset Memory); Listening To Preset Channels - Denon AVR-2809CI Owner's Manual

Symbols used to indicate buttons in this manual
Button located on both the main unit
and the remote control unit
Button only on the main unit
Button only on the remote control unit
<SOURCE SELECT>
uiop
<TUNING PRESET> <STATUS>
XM
[ SAT TU]
( mode)
[A ~ G]
[ ]
[MEMO]
[SEARCH]
uiop
[ENTER]
[CHANNEL + –]
[SAT TU2]
(AMP mode)
[NUMBER]

Checking the XM Signal Strength and
Radio ID
BUTTON
1
<SOURCE SELECT>
Either turn
<BUTTON>
(AMP mode) to select "XM".
[BUTTON]
2
<STATUS>
Press
display.
The display will switch as shown below, depending on the
reception conditions.
Display
GOOD Signal strength is good
MARGINAL Signal strength is marginal
WEAK Signal strength is weak
NO No signal
3
Adjust the position of the antenna until "SIGNAL:
GOOD" is shown on the display.
4
<STATUS>
Press
SIRIUS
(example: "XM001") is displayed.
[ SAT TU] 5
[ ]
Press
( mode)
The radio ID is shown on the display.
[A ~ G]
[ ]
[MEMO]
[SEARCH]
uiop
The strength of both the XM satellite and terrestrial signals can be
checked at menu "Input Setup" – "Antenna Aiming" (vpage 39).
[CHANNEL + –]
[SAT TU1]
(AMP mode)
[NUMBER]
[SAT TU2]
or press
until "SIGNAL" appears on the
Status
until the channel you want to check
and select channel 0 (XM000).
Radio ID
Presetting Radio Channels
(Preset Memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel you want to preset.
2
[MEMO]
Press .
3
[A ~ G]
Press to select the block in which the channel
is to be preset.
4
[CHANNEL + –] [NUMBER (1 ~ 8)]
Press or
the preset number.
5
[MEMO]
Press again to complete the setting.
To preset other channels, repeat steps 1 to 5.
NOTE
Preset channels are erased by overwriting them.

Listening to Preset Channels

Operation on the Main Unit
<TUNING PRESET>
Press , then turn
to select the preset channel.
Operation on the Main Remote control Unit.
1
[A ~ G]
Press to select the memory block (A to G).
2
[CHANNEL + –] [NUMBER (1 ~ 8)]
Press or
the desired preset channel.
to select
<SOURCE SELECT>
to select