Installing the Power Supply Bay
1. Slide the power supply bay in from the front of the chassis.
2. Align and tighten the three captive Phillips-head retaining screws at the rear of the bay and the
two captive Phillips-head screws at the top of the bay.
3. Replace the fan bay and tighten the three internal Phillips-head captive screws and the two
external captive Torx head (T-15) to secure the assembly.
4. Slide the E-bay forward until the locating pins reach the end of their travel, AC and DC
connectors should mate securely, tighten the two captive Phillips-head screws at the rear of the
chassis to secure the E-bay.
5. Follow the instructions under Installing the Peripheral Bay.
6. Replace the cable management plate on to the fan bay.
7. Replace all six fans into the fan bay.
8. Replace all power modules into their respective slots.
9. Follow the instructions under Installing the Top Cover.
198