Replacing A Processor; Removing A Power Pod - Dell 3250 Product Manual

Replacing a Processor

In order to replace a processor, the power pod must first be removed. Follow the instructions
below, in order, to:
1. Remove the power pod
2. Remove the processor
3. Install a replacement processor
4. Reinstall the power pod

Removing a Power Pod

To remove a processor, the power pod must first be removed. To remove a power pod, refer to
Figure 62 to identify the power pod, and use the following instructions to remove it:
1. Power down the system by pressing and holding the power button on the front panel for several
seconds.
2. Unplug both AC power cords to remove standby power from the server.
3. See the warnings and cautions under Removing and Installing the Top Cover.
4. Follow the instructions under Removing the Top Cover.
5. Disconnect the Y-cable to the power pod by releasing the connectors.
6. Loosen the four captive screws on the power pod and slide the power pod away from the
processor to disengage it from its connector.
7. Lift the power pod out of the system.
181