Firewall Settings - D-Link DVG-G1402S User Manual

DVG-G1402S User's Manual
Using the Configuration Utility (continued)
IP Address Destination:
Subnet Mask Destination:
Destination Start/End Port:
< : specifies the port numbers less than and equal to the Start Port number
> : specifies the port numbers greater than and equal to the Start Port number
= : sets the port number equal to the Start Port if there is no End Port specified; if an End Port
number is specified, this defines a range of ports to filter. The range is defined as the port numbers
between the Start Port and End Port, including the Start and End Port numbers.
D-Link Systems, Inc.
Pass or Block:
Protocol:
IP Address Source:
Subnet Mask Source:
Source Start/End Port:
Advanced > Firewall
Enter the MAC address of the computer or device to allow
connectivity to the DVG-G1402S.
Select to enable or disable the rule.
Enter the IP address of the source computer.
Enter the IP address of the destination computer.
Enter the subnet mask of the source computer.
Enter the subnet mask of the destination computer.
Enter the port range you want to open. If you want to open only
one port, enter the same port in both boxes.
Enter the port range you want to open. In most cases, the source
and destination port(s) will be the same.
Using the Configuration Utility
34