D-Link DVG-G1402S User Manual page 11

DVG-G1402S User's Manual
1
Turn off your computer.
2
Disconnect the power to your Cable/DSL Modem (unplug or turn off the power
switch).
3
Unplug the existing Ethernet cable that is connected to your Cable/DSL Modem's
LAN or Ethernet port. Leave the other end of this cable attached to your PC.
4
Plug the Ethernet cable connector that you just removed from the modem into one of
the four LAN ports on the back of the DVG-G1402S. The other end remains attached
to the PC.
5
Attach one end of the Ethernet Cable (blue) provided in this package to the LAN or
Ethernet Port on the Cable/DSL Modem.
6
Attach the other end of the provided Ethernet Cable to the WAN Port of the
DVG-G1402S.
7
Attach one end of the provided phone cable (black) to a standard analog telephone.
8
Attach the other end of the phone cable to the phone port labeled 1 on the rear panel
of the DVG-G1402S.
9
Reconnect the power to the Cable/DSL Modem (plug in or turn on the power switch).
10
Connect the Power Adapter to the Power Connecter on the DVG-G1402S.
11
Connect the other end of the Power Adapter to an available electrical outlet (Wall Socket
or Surge Protector).
12
Restart your PC.
Next you must configure your DVG-G1402S. If you are using a DSL Modem with a
PPPoE or DHCP connection, you will need to continue on to the following section. If
you are using a Cable Modem, and your service provider requires a MAC address, skip
this section and refer to the section titled "MAC Cloning for Cable Connection." Also be
sure to change your computer's IP settings to DHCP (to automatically be assigned an
IP address from the DVG-G1402S) regardless of what type of Internet connection you
have (Please refer to your NIC card's manual for detailed information). If your cable
service provider does not require a MAC address, setup of the DVG-G1402S with a
modem and computer is complete.
D-Link Systems, Inc.
Connecting the DVG-G1402S Directly
to a Modem and Computer
Getting Started
11