D-Link DVG-G1402S User Manual page 54

DVG-G1402S User's Manual
Frequently Asked Questions
5) Check your IP address. Your computer must have an IP address in the same range
of the VoIP router (192.168.15.xxx) where xxx is between 2 and 254. The default
gateway address must be the LAN IP address of the VoIP route (192.168.15.1).
Q: How do I configure my router to work with a Cable modem connection?
A: This FAQ is for most satellite and cable connections (IE Adelphia, AT&T, CableOne,
Cablevision, Charter, Cogeco, Comcast, Cox, DTG, Insight, KingWood, Knowlogy,
MediaOne, Millenium, Optimum, RCN, RoadRunner, Rogers, and Shaw). These
instructions will also work for DSL users that do not use PPPoE (AllTel, BellSouth,
Coastal Utilities, Cyberonic, Empower, MSN, Qwest, Roseville, TC3Net, Telus, and
Verizon).
Note: Please configure the router with the computer that was last connected directly
to the cable modem. Also, you can only use the Ethernet port on your modem. If you
were using the USB connection before using the router, then you must turn off your
modem, disconnect the USB cable and connect an Ethernet cable to the WAN port
on the router, and then turn the modem back on. In some cases, you may need to call
your ISP to change connection types (USB to Ethernet).
1) Log into the web-based configuration by typing in the IP address of the router
(default:192.168.15.1) in your web browser. The address 192.168.15.1 is NOT on the
Internet. The web-based configuration is built-in to the router.
2) Click the Home tab and click the WAN button. Dynamic IP Address is the default value,
however, if Dynamic IP Address is not selected as the WAN type, select Dynamic IP
Address by clicking on the radio button. Click Clone Mac Address. Click on Apply to
save the changes.
3) Power cycle the cable modem and router:
Follow step 1 and log back into the web configuration. Click the Status tab and click
4)
the Device Info button. If you do not have a public IP address under the WAN heading,
try turning off/on the router. If may take up to 5 minutes to connect to the Internet.
D-Link Systems, Inc.
a. Turn the cable modem off.
b. Turn the router off. Leave off for about 2 minutes.
c. Turn the cable modem on (first).
d. Wait until you get a solid cable light on the cable modem.
e. Turn the router on and wait about 30 seconds.
FAQs
54