Static Ip Address And Subnet Mask; User Name - D-Link DXS-3250 Web/Installation Manual

•

User Name

•
SNMP Community strings

Static IP Address and Subnet Mask

IP interfaces can be configured on each port of the device. After entering the configuration command, it is recom-
mended to check if a port was configured with the IP address by entering the "show ip interface" command.
The commands to configure the device are port specific.
To manage the switch from a remote network, a static route must be configured, which is an IP address to where
packets are sent when no entries are found in the device tables. The configured IP address must belong to the
same subnet as one of the device IP interfaces.
To configure a static route, enter the command at the system prompt as shown in the following configuration
example where 101.101.101.101 is the specific management station, and 5.1.1.100 is the static route:
configure
Console#
interface vlan
Console(config)#
ip address
Console(config-if)#
exit
Console(config-if)#
ip route
Console# 192.168.2.0/24 100.1.1.33
Note
100.1.1.33 is the IP address of the next hop that can be used to reach the management network
192.168.2.0.
show ip interface
Console#
Proxy ARP is disabled
IP Address I/F
----------- --------
100.1.1.1/24 vlan 1
User Name
A user name is used to manage the device remotely, for example through SSH, Telnet, or the Web interface. To
gain complete administrative (super-user) control over the device, the highest privilege (15) must be specified.
Note
Only the administrator (super-user) with the highest privilege level (15) is allowed to manage the device
through the Web browser interface.
For more information about the privilege level, see the CLI Reference Guide.
The configured user name is entered as a login name for remote management sessions. To configure user name
and privilege level, enter the command at the system prompt as shown in the configuration example:
enable
Console>
configure
Console#
username
Console(config)#
1
100.1.1.1 255.255.255.0
Type
-----------
static
password privilege
admin lee
Page 34
Configuration Overview
Directed
Broadcast
-------------
disable
15
Initial Configuration