Gl2: W0502 The Parameter Is Out Of Range; Gl2: W0504 This Command Is Not Supported - Canon imagePROGRAF iPF750 User Manual

Messages regarding HP-GL/2
Messages regarding HP-GL/2
This type of paper is not compatible with HP-GL/2.
The printer has received a HP-GL/2 print job that
cannot be printed on the paper that has been
advanced.
GL2: Wxxxx The memory is full. (xxxx is 0501, 0903, or
0904)
The printer memory is full.

GL2: W0502 The parameter is out of range.

A parameter specied in a HP-GL/2 command is out
of the supported range.

GL2: W0504 This command is not supported.

The printer has received an unsupported HP-GL/2
command.
710 Error Message
Cause
Cause
Cause
Cause
Corrective Action
Follow these steps to replace the type of paper in
the printer.
1.
Press ▲ or ▼ to select Stop Printing, and then
press the OK button.
2.
Replace the paper with a type compatible with
HP-GL/2. For details on paper compatible with
HP-GL/2, refer to the Paper Reference Guide.
(→P.95)
Press ▲ or ▼ to select Print, and then press the OK
button to resume printing. However, note that this
error may cause paper jams and affect the printing
quality.
Corrective Action
Because the entire print job could not be received,
the printer may not be able to print the entire original.
Check the printing results.
Corrective Action
Check the print job.
If you have specied ProcessingOption > Warning
> On in the Control Panel menu, set it to Off instead.
Corrective Action
Check the print job.
If you have specied ProcessingOption > Warning
> On in the Control Panel menu, set it to Off instead.