Canon imagePROGRAF iPF750 User Manual page 581

Conguring the IP Address Using the Printer Control
Panel
This topic describes how to congure the printer's IP address on the Control Panel.
1.
On the Tab Selection screen of the Control Panel, press ◄ or ► to select the Settings/Adj.
tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
2.
Press the OK button.
The Set./Adj. Menu is displayed.
3.
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4.
Press ▲ or ▼ to select TCP/IP, and then press the OK button.
5.
Press ▲ or ▼ to select IPv4, and then press the OK button.
6.
Press ▲ or ▼ to select IPv4 Settings, and then press the OK button.
7.
Press ▲ or ▼ to select IP Address, and then press the OK button.
8.
After you press ◄ or ► to select the input eld, numerical input is possible.
9.
Press the ▲ or ▼ button to enter the value.
Note
•
Pressing the ▲ button increases the number by 1. The maximum value is "9," after which "0" is
displayed.
•
Pressing the ▼ button decreases the number by 1. The minimum value is "0," after which "9" is
displayed.
•
Hold down ▲ or ▼ to increase or decrease the value continuously.
•
Make sure the IP address you enter for the printer is not the same as any computer IP address
in your network.
10.
Repeat steps 8 and 9 to complete the settings, and then press the OK button.
11.
Press the Menu button.
If you have changed the settings, a conrmation message is displayed. Press ▲ or ▼ to select
Yes, and then press the OK button.
Network Setting
Network Setting 565