Prepare For Parts Replacement; Parts Replacement Time Has Passed; Error In Cutter Position; Multi-Sensor Error - Canon imagePROGRAF iPF750 User Manual

Other Messages

Prepare for parts replacement.

It is almost time to replace consumables for which
service is required.

Parts replacement time has passed.

It is past the recommended time to replace
consumables for which service is required.
Unknown le.
Data sent to keep the printer up to date (such as
paper information) is in the wrong format.
You have uploaded rmware for a different model.

Multi-sensor error

Direct sunlight or strong lighting may be shining on
the printer and causing the sensor to malfunction.
The performance of a sensor inside the printer may
be impaired.

Error in cutter position.

The Cutter Unit stops in the middle of cutting.
712 Error Message
Cause
Cause
Cause
Cause
Cause
Corrective Action
You can continue to use the printer for some time
until Parts replacement time has passed. will be
displayed.
Contact your Canon dealer for assistance.
Corrective Action
Contact your Canon dealer for assistance.
Corrective Action
Check the data. Turn off the printer and wait a while
before restoring power, and then resend the data.
Check the rmware version. Turn off the printer and
wait a while before restoring power, and then resend
the rmware.
If the message is displayed again, contact your
Canon dealer for assistance.
Corrective Action
Take steps to ensure the printer is not used when
exposed to direct sunlight or strong lighting.
Turn off the printer and wait at least three seconds
before restoring the power.
If the message is displayed again, contact your
Canon dealer for assistance.
Corrective Action
1.
Push the Release Lever back and remove the
paper.
2.
Pull the Release Lever forward.