CanyCom Masao CMX2302 Operator's Manual page 99

3. Set cutting height adjust lever to [150] for CMX106 and CMX1808. Shift auxiliary
transmission shift lever to [L] (low speed) and drive machine slowly forward onto the
bed. Pay attention not to hit the loading lamp or the bed when loading on a transporter.
4. Park machine according to the instructions in "Parking" (Page 34). Tie the machine
with rope or tie-down belts and secure it onto the bed of the transporter securely.
Hoisting
• When hoisting the machine, never go under the machine. The machine can fall,
resulting in death or injury.
• License or certification is required to operate a crane. Check your local
regulations.
• Use hoisting sling of sufficient strength. Always use the slings of the same
length when more than one is used.
• Pay special attention to the center of gravity and the balance of the machine
when hoisting.
• Always stop the engine before hoisting. Never start the engine when hoisted.
5332M-0702-010E
Transporting
1. Raise the seat.
2. Attach hoisting slings to the 2 lift hooks and
hoist the machine.
Hooks
-89-
7