CanyCom Masao CMX2302 Operator's Manual page 75

5335M-0507-050E
Drain Plug
5347M-0507-060E
Maintenance
Filling - Models without charge-pump
1.
2.
MIN
3.
Changing - Models without charge-pump
1.
2.
3.
4.
Release Lever
NOTE
• The HST system cannot be fully drained due
• Do not operate the drive pedal or drive lever
5.
6.
7.
8.
9.
10. Restart the engine and drive the machine
11. Check the oil level. If it is low, fill.
12. Perform 10-12 until the oil level stabilizes.
13. Check if there is no oil leak.
14. After changing the HST oil, check the oil
Remove the cap on the HST oil reservoir.
Fill the specified HST oil into the reservoir so
that the oil level is above [MIN] line on the
reservoir.
Reinstall the cap back in place and screw it
securely.
Remove the rear cover.
Have an appropriate oil drain pan.
Remove the filler cap.
Remove the drain plug to drain HST oil.
to its design.
with the HST oil drained. Doing so lets air
into the circuit, necessitating to bleed the
circuit.
Reinstall the drain plug.
Fill fresh oil to the level.
Reinstall the filler cap.
Reinstall the rear cover and close the engine
hood.
Start the engine and run it for a while. Stop it
and check the HST oil level.
back-and-forth from standstill several times.
level every 10-30 minutes of use for a while
and fill as necessary.
-65-
5