Brother MFC-440CN User Manual page 142

Error Message
Ink Empty
Low Temperature
Media Error
Near Empty
No Caller ID
(U.K. and Ireland only)
No Cartridge
No File
No Paper Fed
No Response/Busy
Not Registered
130
Cause
One or more of the ink cartridges
is empty. The machine will stop all
print operations. While memory is
available, black and white faxes
will be stored in the memory. If a
sending machine has a colour fax,
'
the machine's handshake
ask that the fax be sent as black
and white. If the sending machine
has the ability to convert it, the
colour fax will be stored in the
memory as a black and white fax.
The print head is too cold.
The media card is either
corrupted, improperly formatted,
or there is a problem with the
media card.
One or more of the ink cartridges
are running out of ink. If a sending
machine has a colour fax, the
' '
machine's handshake will ask
that the fax be sent as black and
white. If the sending machine has
the ability to convert it, the colour
fax will be received into memory
as a black and white fax.
There is no incoming call history.
You have not received any calls,
you have not activated the Caller
ID feature on your machine, or
you have not subscribed to the
Caller ID service from your
telephone company.
An ink cartridge is not installed
properly.
The media card in the media drive
does not contain a .JPG file.
The machine is out of paper or
paper is not properly loaded in the
paper tray.
The paper is jammed in the
machine.
The number you dialled does not
answer or is busy.
You tried to access a Speed Dial
number that is not programmed.
Action
Replace the ink cartridges. (See Replacing
the ink cartridges on page 136.)
'
will
Allow the machine to warm up.
Put the card firmly into the slot again to
make sure it is in the correct position. If the
error remains, check the media drive by
putting in another media card that you
know is working.
Order a new ink cartridge.
If you want to use the Caller ID feature call
your telephone company. (See Caller ID
(MFC-660CN and MFC-845CW only) (For
U.K. and Ireland only) on page 52.)
Reinstall the ink cartridge. (See Replacing
the ink cartridges on page 136.)
Put the correct media card into the slot
again.
Do one of the following:
Refill the paper in the paper tray, and
then press Mono Start or
Colour Start.
Remove the paper and load it again
and then press Mono Start or
Colour Start.
See Printer jam or paper jam on page 134.
Verify the number and try again.
Set up the Speed Dial number. (See
Storing Speed-Dial numbers on page 61.)