Before You Call For Service - Dacor Epicure ER30D Use And Care Manual

Problem Solution Guide - Oven
NOTE: See Common Problems When Using the Bake Mode in the Operating the Oven section for problems with cooking food.
PROBLEM
Nothing works.
Oven will not heat.
Oven shuts off by itself after it
has been on for 12 hours.
Time on display not correct.
Time flashes on display.
Oven does not self-clean.
Oven lights will not work.
Foods over or under cook.
Cooling fan continues to run
after oven is turned off.
Oven door will not open.

Before You Call for Service

MAY BE CAUSED BY
Range not connected to electrical
power.
Power to range is off.
Control panel locked.
Power outage.
Oven setting not correct.
Oven set for delay timed cooking.
Attempting to broil with meat probe
connected.
12 hour timer is on. Unit is set
to turn off automatically after 12
hours of continuous use.
Time of day not set.
Power failure or power was turned
off.
Power failure or power was turned
off.
Door not shut tightly.
Oven set for delay timed cleaning.
Oven not set properly.
Meat probe connected.
Light bulbs burned out.
Oven in self-clean mode.
Incorrect cooking time or
temperature.
Normal operation.
Oven is set to self-clean.
Have electrician connect range to properly wired electrical
connection.
Turn power on at junction box. Check for tripped circuit
breaker or blown fuse.
Press CANCEL/SECURE key for 4 seconds to reactivate
control panel.
Contact power company.
Press CANCEL/SECURE, then follow instructions in
Operating the Oven section of this manual.
Oven will turn on automatically at preset time. Press
CANCEL/SECURE to return to normal operation.
Broil and convection broil settings will not work when meat
probe is connected. Disconnect meat probe.
Turn off 12 hour timer. See page 14.
Set time. See Setting Up Your Range section.
Reset time. See Setting Up Your Range section.
Reset time. See Setting Up Your Range section.
Check for obstructions. Close door tightly.
Oven will start to self-clean at preset time. Press CANCEL/
SECURE to return to normal operation.
Follow instructions in Cleaning and Maintenance section of
this manual.
Oven will not start self-clean cycle when meat probe is
connected. Disconnect and remove meat probe.
Replace light bulbs. See Cleaning and Maintenance
section.
Lights do not work when oven is in self-clean mode.
Follow instructions in Operating the Oven section.
The cooling fan may run for a while after the oven is turned
off, until the internal parts have cooled.
Check display. If "LOCK" appears on display oven door
cannot be opened. Wait for oven to complete self-clean or
press CANCEL/SECURE. Door will unlock once oven has
cooled.
30
WHAT TO DO