Before You Call For Service - Dacor Discovery DYRP48DS Use And Care Manual

Replacing the Light Bulbs
• To prevent electrical shock and/or personal injury, make
certain that the oven and light bulbs are cool and that power
to the range has been turned off at the circuit breaker panel
or fuse box before replacing the light bulbs.
• Always make sure the lens covers are in place when using
the ovens. The lens covers protect the light bulbs from
breakage caused by high temperatures or mechanical shock.
• Replacing the lens cover without lining up the cutout with the
light socket will damage the light fixture.
• Do not use a screwdriver to remove the lens.
Light bulb replacement is considered to be a homeowner
maintenance operation. If the lights do not work, before
replacing them, please consult page 53 of the Before
You Call For Service section.
IMPORTANT
Do not touch the replacement halogen light bulbs with
your fingers. Halogen bulbs are sensitive to the oils
from your hand. The oils from your hand will stick to
the bulb and cause it to burn out faster than normal.
Problem Solution Guide - Oven
NOTE: See Common Problems When Using the Bake Mode on page 23 for problems with cooking food.
Problem
Nothing works. Control panel is
not lit.
Nothing works/control panel
does not respond. Control
panel is lit.
Control panel, blank, dim or
only time and date is shown.
Normal screen is missing from
display.
No sound(s).
Care and Cleaning
WARNING

Before You Call for Service

May Be Caused By
Range not connected to electrical
power.
Power to range is off.
Power outage.
Control panel locked (Locked
appears on display).
Range's computer needs to be
restarted.
Energy saving mode activated.
Android operating system is show-
ing.
Volume turned down.
To replace the light bulbs...
1. Replace the light bulb only with Dacor part number
100429. See page 45 for ordering information.
2. Turn off power to the range at the circuit breaker
panel or fuse box.
3. Hold your hand under the lens for support and gently
pry it loose using a spatula or table knife. Pull the lens
cover straight out.
4. Grasp the old bulb and pull it straight out of the
socket.
5. Using a glove, insert the new bulb into the socket.
6. As you reinstall the lens cover, line up the cutout on
the inside rim with the light socket. Gently press it
into its original position.
7. Turn the power
to the oven back
on at the circuit
breaker panel or
fuse box.
Have a licensed electrician connect the range
to properly wired electrical connection.
Turn on power at circuit breaker or fuse box.
Check for tripped breaker or blown fuse.
Contact power company.
Touch CANCEL RIGHT or CANCEL LEFT key
for 5 seconds to reactivate control panel.
To restart computer, touch and hold BACK
key, continue to hold BACK as you touch and
hold the HOME key. Hold both keys for 5 sec-
onds, until computer restarts.
See page 11 to change settings or touch
display to reactivate.
Touch Dacor Cooking or HOME to return to
oven home screen.
Adjust volume controls. See Oven Tone Set-
tings on page 11.
52
Light
bulb
socket
Cutout on inside
rim of lens
What to Do
Light