Dacor Epicure ER30D Use And Care Manual page 11

CONTROL PANEL SETTINGS
Setting the Time
IMPORTANT:
• The clock cannot be set during delay timed cooking or if one or
both timers are in use.
• After a power failure, the time on the display may flash,
indicating that the time may not be correct.
To set the time:
1. Press the CLOCK key. "TIME" will flash on the display.
2. Enter the current time and press START. For example: For
12:08 Press 1-2-0-8 on the keypad, then START.
IMPORTANT: After pressing the clock key, you must enter the
time and press START soon afterward. If you wait longer than six
seconds between pressing keys, the display will go back to the
original setting.
Clock Key Clock Key
24/12 Hour Clock (Military Time)
The range is set to 12-hour (non-military) time at the factory. 24-
hour time is also known as military time. 1:36 PM = 13:36 military
time.
If you want to switch the clock to 24 hour time or switch from
military back to regular time:
1. Press and hold the clock key for six seconds. The display will
indicate the mode the clock is currently set to, 12 HR or 24
HR.
2. Press the SELF-CLEAN key within six seconds to change the
clock mode. To leave the setting as is, do not touch any keys.
3. Wait six seconds. The control panel will go back to the regular
clock display, set to the new time standard. If you have set
the clock to 24 hour time, the keypad will allow you to enter
military time when setting the clock.
Setting Up Your Range
Setting the Temperature Scale
The control panel allows you to select the temperature scale
(Fahrenheit or Celsius) it uses to display the cooking temperature.
The oven is preset at the factory to Fahrenheit.
To change the temperature scale:
1. Press and hold the BROIL key for six seconds.
2. The display will indicate the temperature scale the control
panel is currently set to, "F" or "C".
3. Press the SELF-CLEAN key within six seconds to change the
temperature scale. To leave the setting as is, do not touch any
keys.
4. Wait six seconds. The control panel will go back to the regular
clock display, set to the new temperature scale.
Control Panel Position
The control panel can be swiveled to a 50° angle for easier
viewing and use.
To pivot the control panel:
1. Push in on the bottom of the control panel where it says
"PRESS HERE". The control panel will pivot up.
2. Pull up on the bottom of the control panel housing (under
"PRESS HERE") until it locks in place.
To put the control panel back in the vertical position:
1. Pull up on the bottom of the control panel housing (under
"PRESS HERE") to unlock it.
2. Push in where it says "PRESS HERE" until it locks into the
vertical position.
Pull up here
When changing the control panel position, push in only on the
spot marked "PRESS HERE". If you push in on the right or left
side you may damage the pivot mechanism.
9
Press here
CAUTION