Cleaning And Maintenance - Fagor CG-1100 Instructions For Use Manual

interior 13/12/04
the coffee into the jug. When the filtering
process is completed, the heater plate
will keep the coffee warm.
• If you wish to pour a cup of
before the filtering process has finished,
remove the jug from the heater plate,
pour and then replace immediately.
• When the jug is
start/stop switch off (the pilot light will go
out), unplug the appliance leave to cool
for 10 minutes before repeating the
coffee-making operation or cleaning.
Precautions to be taken while using the
appliance
• Do not use warm or hot
use cold water. Do not use any other
liquid except water.
• To prevent the water in the filter from
overflowing the jug lid should be
correctly fitted in order to ensure that the
anti-drip value is opened, enabling the
water to pass through to the jug.
• Leave the coffeemaker to cool before
refilling the deposit. If the deposit is filled
while hot, steam may be generated that
could cause burns.
Do not move the coffeemaker while in
use.
Anti-drip valve
The anti-drip value is located underneath the
filter-holder and is activated when the jug is
removed from the heater plate. It enables the
jug to be removed to pour a cup of coffee
during the filtering process. Make sure that
the equivalent of at least two cups of coffee
has filtered into the jug before removing
during the filtering process.
Warning: replace the jug immediately
after pouring the cup of coffee
the filtering process to continue. If the jug is
not returned immediately, the filter may
overflow.
12:28 Página 10
coffee
empty, turn the
water. Always
to enable
Filters
The coffeemaker is supplied with a
permanent filter. However, if you prefer
disposable filters, use cone filters:
• 1x2 mod CG-806.
• 1x4 mod CG-810,
CG-1100.
6. HOW TO MAKE A PERFECT
CUP OF COFFEE
For an even more delicious taste and
aroma, use freshly ground coffee.
Use medium, not fine ground coffee.
Store coffee in a dry place. Once the
packet has been opened, close firmly and
store in the refrigerator in order to
conserve its aroma.
The heater plate will keep the freshly
made coffee warm, but it tastes better if
drunk immediately after filtering.

7. CLEANING AND MAINTENANCE

Always leave the appliance to cool before
cleaning and make sure that the
start/stop switch has been turned off and
the coffeemaker unplugged from the
mains.
Clean the filter-holder, jug and jug lid in
warm soapy water. Rinse well and dry
thoroughly before replacing.
Clean the outside of the coffeemaker with
a damp cloth. Do not use detergent or
abrasive cleaning products.
Do not submerge the appliance in
water or place under an open tap.
11
CG-810V, CG-812,