Part-Program Directory - Fagor 8025 GP Operating Manual

3.6.3. Part-program directory

- Press [PROGram DIRectory]. The CNC shows a list of up to 7 part-programs with their
sizes (in characters) as well as the total free memory available.
Also, if the first block of each program has a comment, it will appear next to the program size.
Example: PROG.
00001
00002
Atention:
When having more than 7 programs in memory, use the
scroll them up and down.
3.6.3.1. Delete a complete program
- Press [PROG DIR]. T he screen will show: DELETE PROGRAM.
- Press DELETE. The message DELETE PROGRAM appears on the screen.
- Key in the number of the program to be deleted. Check the number. If the number is
correct, press ENTER.
If the number is not correct:
- Press the CL key. We cancel the number with this key.
- Key-in the correct number.
- Press ENTER.
Atention:
If the [CONTINUE] key is pressed during this sequence, access is
obtained to the original display of this MODE.
DELETION OF ALL PROGRAMS
If all the programs in the memory must be deleted, key-in 99999 when DELETE PROGRAM
is displayed, and then press ENTER; if the key Y is pressed immediately afterwards, all the
programs except the one identified by parameter P802 will be deleted.
8025/8030 CNC OPERATING MANUAL
CHAR.
42 PART 1
115 PART 2
28513 free characters
keys to
43