Table of Contents
Advertisement
2.4.0.1
Tool setting:
Teach
When going into Teach mode, if the DRO was in INC mode, it switches to ABS mode.
2.4.0.2
Setting the tool by touching a part of known diameter:
Enter tool number. Press Enter.
Move the X axis until the tool touches the part. Preset the
part diameter.
Move the Z axis until the tool touches the part. Preset the
value for the Z axis.
Press button to validate.
2.4.0.3
Setting the tool by touching a part of unknown diameter:
When the part must be removed to measure its dimensions, use the HOLD function.
Enter tool number. Press Enter.
Move the X axis until the tool touches the part.
Move the Z axis until the tool touches the part.
Press HOLD for both axes.
Hold
Remove the part and measure it.
Preset the X axis with the measured diameter value.
Preset the value for the Z axis.
Press button to validate.
These tool presets are kept in memory even when the unit is powered off up to a maximum of 10
years.
Notes:
The presets done with any tool in incremental mode change the part zero for all the tools.
If a tool offset has been preset in Z
mode (Z
The tool offsets are referred to the machine zero found at the time. When turning the DRO on, it is
necessary to find the same reference mark.
2.4.1
View tool table:
Tool
Table
View tool offset table.
, Z
or Z) when using it to machine the part.
1
2
, Z
or Z (Z1 + Z2) mode, that tool must be used in the same
1
2
40i TS - v1205 - Installation/Operation - (7/29)
Advertisement
Table of Contents
