Entering An S Value; Entering An M Value; Operation Of The Cnc As A Readout - Fagor 8025 GP Operating Manual

3.5.5.2. Entering an S value

- Press the S key
- Key in the required value
- Press

3.5.5.3. Entering an M value

- Press the M key
- Key in the required value
- Press
Atention:
Except for M41,M42,M43 and M44 which are automatically generated by the
CNC when an S value requiring range change is programmed.

3.5.6. Operation of the CNC as a readout

Once the JOG operating mode is selected, if the external MANUAL input is activated, the CNC
acts as a readout.
In this case, the machine has to be moved by means of external controls and the analog signals
must be generated outside the CNC.The S and M functions may be entered in this form of
operation.
If when operating in this mode, the software travel limits (set via machine-parameters) are
overrun, the CNC will send the relevant error code and will only allow the machine to be moved
to bring it back to the permitted zone.
8025/8030 CNC OPERATING MANUAL 35