AJAX KeyPad TouchScreen Fibra User Manual page 38

After activation, KeyPad TouchScreen will display a screen for switching the
keypad to the access devices registration mode. Click the Start button.
A screen updates automatically if the external power supply is connected and the
Always Active Display toggle is enabled in the keypad settings.
The screen for switching the keypad to the registration mode will appear on
all KeyPad TouchScreen of the system. When an admin or PRO with rights to
con gure the system starts registering Tag/Pass at one keypad, the rest will
switch to their initial state.
9. Present Pass or Tag with the wide side to the keypad reader for a few
seconds. It is marked with wave
addition, you will receive a noti cation in the Ajax app and on the keypad
display.
If the connection fails, try again in 5 seconds. Please note that if the maximum
number of Tag or Pass devices has already been added to the hub, you will
receive a corresponding noti cation in the Ajax app when adding a new device.
Both Tag and Pass can work with several hubs at the same time. The maximum number
of hubs is 13. If you try to bind a Tag or Pass to a hub that has already reached the hub
limit, you will receive a corresponding noti cation. To bind such a key fob/card to a new
hub, you will need to
If you need to add another Tag or Pass, click Add Another Pass/Tag in the app.
Repeat steps 6–9.
How to delete a Tag or Pass from the hub
Resetting will delete all settings and bindings of key fobs and cards. In this case, the
reset Tag and Pass are only removed from the hub from which the reset was made. On
other hubs, Tag or Pass are still displayed in the app but cannot be used to manage the
security modes. These devices should be removed manually.
icons on the body. Upon successful
reset it .