Inputting Numerals - Omron ZX-T Operation Manual

Section 3
BASIC OPERATION

Inputting Numerals

This section describes how to input numeric values for threshold and output settings.
The example of direct input of the low threshold value will be used.
Changing the low threshold from 0.200 to 0.190
Changing to T Mode
1.
Set the mode switch to T.
Setting Threshold Value
2.
Set the switch to L.
The measured value will be displayed on the main
display. The current setting will be displayed on the sub-
display.
3.
Press any Cursor Key.
The first digit on the sub-display will flash and direct input
will be enabled.
4.
Use the LEFT or RIGHT Key to move the cur-
sor to the first decimal place.
5.
Use the UP or Down Key to display 1.
6.
Repeat steps 4 and 5 to move the cursor to
the second decimal place and display 9.
To cancel the selected setting, use the LEFT Key to move
the cursor to the leftmost digit and press the LEFT Key
again. Alternatively, use the RIGHT Key to move to the
rightmost digit and press the RIGHT Key again. The dis-
play will return to the current setting (0.200 in this exam-
ple).
7.
When you finish adjusting the numeric value,
press the ENT Key to confirm the value.
The display will change from flashing to being lit continu-
ously and the numeric value will be registered.
ZX-T
46
Operation Manual
POWER ZERO ENABLE
(mm)
SUB
SUB
SUB
SUB
SUB
SUB