Omron MX2 DEVICENET OPTION BOARD User Manual page 25

Step-by-Step Basic Installation
Step 4
Step 5
Step 6
Step 7
If removed in Step 2, mount the termi-
nal cover again and tighten the
screw(s).
Push the Option Board into the previ-
ous location of the option board cover
until it clicks into place
Press down on the indicated corner
of the Option Board housing to
ensure proper connection of the
Option Board connector
Check that there is
no gap between the
top edges of the
Option Board and
the Inverter casing.
Section 2-3
11