Specifications - Lectrosonics DSSM-A1B1 Instruction Manual

Specifications

Operating Frequencies:
DDSSM - A1B1 470.100 - 607.950
DSSM/E01-A1B1: 470.100 - 614.375
DSSM-B1C1 (US) 537.600 - 607.950
614.400 - 615.950
653.050 - 662.950
DSSM/E01-B1C1: 537.600 - 691.175
DSSM/E07-941: 941.525 - 951.575
953.025 - 956.225
956.475 - 959.825
Frequency
Selection
Steps: 25 kHz
RF Power output: Selectable; 10, 35 mW or 2mW (HD mode)
Compatibility
Modes: HDM or D2 (all models)
Frequency Stability: ± 0.002%
Spurious radiation: Compliant with ETSI EN 300 422-1
Equivalent input
noise: –120 dBV (A-weighted)
Input level: Nominal 2 mV to 300 mV, before limiting. Greater than
1V maximum, with limiting.
Input impedance: • Mic: 300 or 4.5 k ohm; selectable
• Line: 900 ohm
• Instrument: 1 M ohm
Input limiter: DSP controlled, dual envelope "soft" limiter with
greater than 30 dB range
Gain control range: -7 to +44 dB; digital control, 1 db steps
Modulation
indicators: Dual bicolor LEDs indicate modulation of -20, -10, 0
and +10 dB referenced to full modulation
Audio Performance:
Frequency Response: 35-20 kHz; 35-15 kHz (HDM compat mode)
Low frequency
roll-off: Selectable; 35, 50, 70, 100, 120, 150 Hz
THD: 0.2% (typical)
Controls: Front panel membrane switches with OLED interface
for power on/off and all setup and configuration
controls
Audio Input Jack: Subminiature; locking 3 pin
Antenna: SMA connector; coated, flexible wire, length by
frequency band
Battery: Lithium-ion 3.6 V 1000 mAH LB50 battery pack
(included)
Battery Life: 6 hours per charge @ 35 mW
Weight: 3.5 ounces (100 grams) including lithium battery pack
Dimensions
(housing): 2.59 x 1.9 x .70 in. (66 x 49 x 17 mm)
Emission
Designator: 110KG1E (HD mode); 170KG1E (D2 mode)
Specifications subject to change without notice.
Rio Rancho, NM
NOTE: It is the user's
responsibility to
select the approved
frequencies for the
region where the
transmitter is operating.
Water-Resistant Micro Body Pack Transmitter
For body worn operation, this transmitter
model has been tested and meets the
FCC RF exposure guidelines when
used with the Lectrosonics accessories
supplied or designated for this product.
Use of other accessories may not ensure
compliance with FCC RF exposure
guidelines. Contact Lectrosonics if
you have any questions or need more
information about RF exposure using this
product..
This device complies with FCC radiation
exposure limits as set forth for an
uncontrolled environment. This device
should be installed and operated so
that its antenna(s) are not co-located or
operating in conjunction with any other
antenna or transmitter.
This device complies with ISED Canada
radiation exposure limits as set forth for a
controlled "professional" use only.
Cet appareil est conforme avec les
normes d'Industrie Canada concernant
les limites d'exposition aux radiations
pour un usage professionnel contrôlé
seulement.
21