Grt1-Prt Gsd File - Omron GRT1 - 27-11-2006 Operation Manual

Installation of Configuration Software
Updating the Device
Catalogue
1,2,3...
2-5-3

GRT1-PRT GSD File

4. The user is then prompted to specify the installation directory.
5. Pressing the Next button will summarize the settings after which installa-
tion will commence.
6. When done, the installation program will notify the user of its completion.
After installation of the GRT1-PRT DTM the Device Catalogue in the FDT
Container needs to be updated, to show the new GRT1-PRT DTM in the list of
available devices. For Cx-Profibus the following procedure applies
1. Open the Device Catalogue window in Cx-Profibus.
2. Press the Update button to initiate the update sequence.
After updating, the GRT1-PRT DTM will be shown in the list of available
devices. It can now be used to setup a PROFIBUS network and configure the
Master Unit.
Note In case the required CS1/CJ1W-PRM21 PROFIBUS Master DTM has not
been installed, this needs to be done first to allow the full features of the
GRT1-PRT DTM to be used.
Apart from the GRT1-PRT DTM, OMRON provides a GSD file to allow config-
uration of third-party PROFIBUS Master Units, which do not provide an FDT
Container. The GSD file - OC_09FE.gsd - is available through the OMRON
Web site: http://www.omron-industrial.com/
Section 3-3-3 Setup Using the GSD File discusses configuration of the
PROFIBUS DP Master using this GSD file.
Note Using the GSD file for configuration allows the user to configure the Master
Unit for I/O data exchange with the GRT1-PRT and the SmartSlice I/O Sys-
tem. It does not however, provide the acyclic messaging capabilities to
access parameters and status information in individual SmartSlice I/O Units.
The GRT1-PRT DTM does provide this capability.
The next section will discuss the features of the GRT1-PRT in detail as well
as how to setup, configure and operate the SmartSlice I/O System in a
PROFIBUS network.
Section 2-5
29